Product Categories

Contact Us

Add:North ring Road, Shenze County,Shijiazhuang City,Hebei Province ,China

Tel:+86-311-87513878

Phone:+8613933870601

Fax:+86-311-83525449

E-mail: nonghahajenny@nonghaha.net.cn

Web:www.nhhmachinery.com

News

Home > News > Content
Rotary Tiller Maintenance Can Be Divided Into
Aug 24, 2017

Rotary Tiller Maintenance can be divided into

Rotary tillage maintenance can be divided into two types of maintenance and quarterly maintenance. Duty maintenance refers to the rotary tiller after each operation should be carried out maintenance, including checking the coupling bolts are tightened, machete, plug and cotter and other wearing parts and other defects, check the transmission box, universal joints and bearings are lack of oil , When the problem is found in a timely manner. The so-called quarterly maintenance After the completion of each operation season, should be carried out maintenance, including the complete removal of equipment on the dust, oil, oil, grease, grease, check the blade is excessive wear, check the hood, A comprehensive inspection of the appearance of the machine, add paint, machete, spline shaft on the oil rust and so on. Only by strengthening the maintenance and protection, in order to make the rotary tiller to extend the use of time, to maximize the effectiveness.

Use the tips of the rotary tiller

1. At the beginning of the operation, the rotary tiller should be lifted, first combined with the power output shaft, the knife shaft speed to the rated speed, and then down the rotary tiller, so that the blade gradually into the required depth. It is strictly forbidden to insert the blade into the power output shaft or the sharp descending rotary tiller to avoid causing the blade to bend or break and to increase the load of the tractor.

2. In the operation, should be as low as possible slow, so that can guarantee the quality of operations, so that the soil crushed, but also reduce the wear and tear of the parts. Pay attention to listen to the rotary tiller whether there is noise or metal percussion, and observe the broken soil, till the deep situation. If there is any abnormality, it should be immediately shut down for inspection, and then the operation can be continued.

3. When the ground turns, prohibit the operation, the rotary tiller should be raised, so that the blade away from the ground, and reduce the tractor throttle, so as not to damage the blade. When lifting the rotary tiller, the inclination angle of the universal joint should be less than 30 degrees. If it is too large, it will cause the impact noise to be prematurely worn or damaged.

4. In the reverse, over the ridge and transfer the land, the rotary tiller should be raised to the highest position, and cut off the power, so as not to damage the parts. Such as the distant transfer, use a locking device to fix the rotary tiller.

5. After each shift, the rotary tiller should be serviced. Remove the soil and weeds on the blade, check the fastening of the connectors, add lubricating oil to the lubricating oil, and add butter to the joints to prevent aggravating wear.